Форум за електроника

[Йордан11]

Спешно се нуждая от сервизен режим на TV ORION- Combi . Schneider SVTV 1451 ,с процесор ORION OECO107B 2F3
6432197SAO4F .Моля за информация как да вляза в сервизния режим чрез дистанционното и съответните бутони за влизане в режима на процесора искам да променя звука как да отида в D-K - 5.5 или 6.5 Mhz. Благодаря предварително за отговора

[Филипов]

Пробвай това:

SERVICE MODE LIST
This unit provided with the following SERVICE MODES so you can repair, examine and adjust easily.

To enter SERVICE MODE, Unplug AC cord till lost actual clock time. Then press and hold Vol (-) button of main unit and
remocon key for more than 2 seconds.

The both pressing of set key and remote control key will not be possible if clock has been set. To reset clock, either unplug AC cord and allow at least 30 minutes before Power On or alternatively, discharge backup capacitor.

VOL. (-) MIN 1 Initialization of the factory. NOTE: Do not use this for the normal servicing.

VOL. (-) MIN 2 Horizontal position adjustment of OSD. NOTE: Also can be adjusted by using the Adjustment MENU. Refer to the "ELECTRICAL ADJUSTMENT" (OSD HORIZONTAL).

VOL. (-) MIN 3 Adjust the PG SHIFTER automatically. Refer to the "ELECTRICAL ADJUSTMENT" (PG SHIFTER).

VOL. (-) MIN 4 Adjust the PG SHIFTER manually.
Refer to the "ELECTRICAL ADJUSTMENT" (PG SHIFTER).

VOL. (-) MIN 5 Adjusting of the Tracking to the center position.
NOTE: Also can be adjusted by pressing the ATR button for more than 2 seconds during PLAY.

VOL. (-) MIN 6 POWER ON total hours and PLAY/REC total hours are displayed on the screen. Refer to the "PREVENTIVE CHECKS AND SERVICE INTERVALS" (CONFIRMATION OF HOURS USED ).
Can be checked of the INITIAL DATA of MEMORY IC. Refer to the "WHEN REPLACING EEPROM (MEMORY) IC".

VOL. (-) MIN 7 Releasing of PROTECTION PASSWORD.

VOL. (-) MIN 8 Writing of EEPROM initial data. NOTE: Do not use this for the normal servicing.

VOL. (-) MIN 9 Display of the Adjustment MENU on the screen.
Refer to the "ELECTRICAL ADJUSTMENT" (On-Screen Display Adjustment).

Press the ATR button on the remote control for more than 2 seconds during PLAY. Adjusting of the Tracking to the center position. NOTE: Refer to the "MECHANICAL ADJUSTMENT" (GUIDE ROLLER) and "ELECTRICAL ADJUSTMENT" (PG SHIFTER).

Make the short circuit between the test point of SERVICE and the GND.
The EOT/BOT/Reel sensor do not work at this moment. Refer to the "PREPARATION FOR SERVICING"
_________________
Ако двамата имаме по една ябълка и ги разменим, пак ще имаме по една.
Ако двамата имаме по една идея и ги разменим, ще имаме по две!
Oтопление и ВиК. Интелигентни отплителни системи. Проектиране продажба доставка монтаж